C-SCOPE XD Manual de instrucciones

Instruction ManualCable Avoidance ToolCable Avoidance Tool XDSignal Generator SG-ASignal Generator SG-VCABLE AVOIDANCE TOOLS

Locator Battery CheckSwitch the locator on by pulling up on the On/Off trigger positioned on the underside of the handle. The locator should emit a cl

When in use the locator should always be held upright.NEVER swing the locator such that it moves away from the vertical.Your middle or little finger s

There are three stages to the locating process; searching, pinpointing andtracing1. Turn the function switch to the appropriate mode2. Hold in the On/

Having found the presence of a signal the next stop is to pinpointthe source. The closer the locator is to the signal source thestronger the response.

Using the Locator: TracingHaving pinpointed a service it should now be possible to trace it’s route.1. Carefully follow the direction of the signal ho

Beware of multiple services. The C.Scope Cable Avoidance Tool will not alwaysindicate close services, either side by side or one above the other.Do no

ContentsWarnings Inside Front Cover FeaturesCable Avoidance Tool (and XD Model) 1Signal Generator (SG-A and SG-V Models) 2Locator Operating ModesPower

Digital displayDepth measurement button (XD model only)Detachable loud speakerOn/ Off switchSensitivity control3 position mode switchBattery compartme

On/Off switchLoud/Mute switchPulsed/Continuous output switchHigh power switchLow power switchBatteriesDirect connection socketAuxiliary earth lead soc

The C.Scope Signal Generator (SG-A and SG-V Models)Accessory trayAccessory tray holding clipsEarth stakeDirect connection leadsCrocodile clips Auxilia

NOTE Generally these services should be detectable using the Radio or Generator modes.In Power Mode the locator detects power signals. These power si

In Radio mode, the locator detects signals from radio transmitters. These signals flow through the ground and will tend tofollow the line of least res

Locator Operating Modes: Generator ModeIn Generator mode the locator detects conductors radiating asignal applied by the Signal Generator. The Signal